Power Switch/Led Assembly - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Power Switch/LED Assembly

1. Prepare the computer for disassembly
2. Remove the access panel
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel
5.
Remove the optical drive
6.
Disconnect the braided cables from the black system board connector.
7. Remove the cable from the clips in the optical drive cage.
8. Press the tab on the top of the power switch to disengage it from the chassis, lift the switch upward
to disengage the tab at the bottom of the switch from the chassis, and then pull the power switch
away from the chassis while guiding the wires through the hole in the chassis.
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page 44).
(Removing an Optical Drive on page
43).
68).
Power Switch/LED Assembly
42).
73