10 Post Error Messages; Post Text Messages - HP Pro 2110 Small Form Factor Maintenance & Service Manual

10 POST Error Messages

This appendix lists the error messages and the various audible sequences that you may encounter
during Power-On Self-Test (POST) or computer restart, the probable source of the problem, and steps
you can take to resolve the error condition.

POST Text Messages

The section includes some text messages that may be encountered during POST.
NOTE:
The computer will beep once after a POST text message is displayed on the screen.
Recommended actions in the following table are listed in the order in which they should be performed.
WARNING!
the system board. To reduce the risk of personal injury from electrical shock and/or hot surfaces, be
sure to disconnect the power cord from the wall outlet and allow the internal system components to cool
before touching.
Table 10-1 Numeric Codes and Text Messages
Control panel message
Default BIOS settings have been loaded due
to BIOS update or checksum issue. Press
<F10> to enter Setup. Otherwise, allow the
PC to continue.
ERROR: CPU Fan Has Failed. PC will
automatically power down in a few seconds.
Service PC immediately to prevent damage
to CPU.
ERROR: System Fan Has Failed. Service PC
to prevent damage to the system. Press F2 to
continue.
ERROR: Unsupported CPU installed. PC will
automatically power down in a few seconds.
When the computer is plugged into an AC power source, voltage is always applied to
Description
BIOS has been updated or returned to
default settings.
CPU fan is not connected or may have
malfunctioned.
System fan is not connected or may have
malfunctioned.
Recently installed CPU is not supported by
the system.
Recommended action
Press F10 to enter Computer Setup and
configure the system or ignore the message
and accept the default settings.
1. Reseat the CPU fan.
2. Reseat the fan cable.
3. Replace the CPU fan.
1. Reseat the system fan.
2. Reseat the fan cable.
3. Replace the system fan.
Install a CPU supported by your system.
POST Text Messages 181