System Fan - HP Pro 2110 Small Form Factor Maintenance & Service Manual

12. Reconnect the power cord and any external devices, then turn on the computer.
13. Lock any security devices that were disengaged when the access panel was removed.
14. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for
instructions on using Computer Setup.

System Fan

The front fan assembly is attached to the front of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3. Remove the front bezel
4. Disconnect the fan cable from the red/brown system board connector.
5. Remove the Torx screw that secures the fan to the computer (1).
6. While pressing the tab (2), slide the fan away from the optical drive and then lift it out of the
chassis (3).
Figure 6-16
To install the system fan, reverse the removal procedure.
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
Removing the system fan
88).
89).
87).
System Fan 103