Table of Contents
Advertisement
Removing a slim optical drive bezel blank
On some models, there is a bezel blank covering the slim optical drive bay. Remove the bezel blank before
installing an optical drive. To remove the bezel blank:
1.
Remove the computer access panel and front bezel. See
and
Removing the front bezel on page
2.
To remove the bezel blank, press to the side (1), swing out from the main bezel (2), and then remove the
blank from the bezel (3).
Replacing the front bezel
Insert the three hooks on the bottom edge of the bezel into the rectangular holes on the chassis (1), and then
rotate the top side of the bezel onto the chassis (2) and snap it into place.
10
Chapter 2 Hardware upgrades
Removing the computer access panel on page 7
9.
Advertisement
Table of Contents
