Heat Sink - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Heat sink

The heat sink is secured atop the processor with four captive Torx screws. The heat sink does not
include a fan.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the chassis fan
4. Disconnect the heat sink fan control cable (1) from the white system board connector.
5. If the computer uses a heat sink secured with four Torx screws, loosen the four captive torx T15
screws (2) that secure the heat sink to the system board.
6. Lift the lever (1) that secures the heat sink latch to the heat sink bracket attached to the system
board.
7. After loosening the lever, press downward on the lever to release the square clip (2) from the tab
on the heat sink bracket.
8. Use the lever to maneuver the square clip on the opposite side on the heat sink (3) free from the
tab on the heat sink bracket.
122 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(System Fan on page 103).
88).
87).