Table of Contents
Advertisement
Heat sink
The heat sink is secured atop the processor with two screws that are loosened from the bottom of the system
board.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the system board
4.
From the bottom of the system board, remove the two Phillips screws (1), and the lift the heat sink from
the system board (2).
When reinstalling the heat sink, make sure that its bottom has been cleaned with an alcohol wipe and fresh
thermal grease has been applied to the top of the processor.
Front bezel
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Lift up the three tabs on the top of the bezel (1), and then rotate the top of the bezel downward and
remove it from the computer (2).
To install the front bezel, reverse the removal procedure.
26
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page
15).
(System board on page
23).
(Preparation for disassembly on page
(Access panel on page
15).
14).
14).
Advertisement
Table of Contents
