Set Up The Cw Identifier - Yaesu FT-8800R Operating Manual

4. Press the
desired
ARTS
•
IN RNG
within range, but does not re-confirm with beeps thereafter.
•
ALWAYS
the alert beeps will be heard.
5. Press the
operation has now commenced.
6. Every 25 seconds, your radio will transmit a polling call to the other station. When
that station responds with its own
to confirm that the other station's polling code was received in response to
IN.RNG
yours.
7. Press the
operation.

Set Up the CW Identifier

The feature includes a
ARTS
radio can be instructed to send
field may contain up to 6 characters.
To program the
CW Identifier
1. Press the
2. Rotate the
3. Press the
4. Press the
5. Rotate the
numbers in your callsign.
6. Press the
callsign.
7. When the correct character has been selected, press the
to move on to the next character.
8. Repeat steps 6 and 7 as many times as necessary to complete your callsign.
9. Press the
Main
previously stored (erroneously).
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
knob momentarily, then rotate the
DIAL
beep option. The available options are:
: The beeps are issued only when the radio first confirms that you are
: Every time a polling transmission is received from the other station,
knob momentarily.
DIAL
knob momentarily to exit
DIAL
0.
CW Identifier
DE your-callsign K
:
momentarily to enter the
SET key
knob to select
DIAL
knob momentarily.
DIAL
knob momentarily again to enable entry of your callsign.
DIAL
knob one click clockwise to begin entry of the letters and
DIAL
knob momentarily to set the first letter or number in your
DIAL
key to delete all data after the cursor that may have been
is displayed on the LCD.
OUT.RNG
polling signal, the display will change to
ARTS
operation and resume normal
ARTS
. Every ten minutes during
if this feature is enabled. The callsign
mode.
Set
.
Menu #8 CWID W
ARTS
knob to select the
DIAL
ARTS
operation, the
ARTS
knob momentarily
DIAL
Page 57 of 83