Scan In Memory Mode - Yaesu FT-8800R Operating Manual

4. To cancel scanning, press the
microphone's
1. When you start scanning, the FT−8800R will scan in the upward
direction. If you want to change the direction of the scan while it is
underway, rotate the DIAL knob one click in the opposite direction (in this
case, one click counterclockwise). The scanning direction will reverse and
scan downward.
2. Pressing and holding in the microphone's
scanning to sweep frequencies only on the current band. If you would like
the scanner not to be restricted to the current band, set Menu #4 (BAND) to
BND.OFF to cause the FT−8800R to hop to the low edge of the next-
highest band when the VFO frequency reaches the high end of the current
band (or vice- versa).

Scan in Memory Mode

In mode, you can set the type of scan to be performed and set the method in
Memory Scan
which each Memory channel will be scanned.
Set the Type of Memory Scan
You can configure the
(default) or a
Preferential Memory
Standard
(default)
Preferential
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
key. 0.
PTT
keys on the
FT−8800R
scan when pressed.
Types of Memory Scans
• All
Memory
scanned.
• Set
Menu #35
• See
Standard Memory Scan
• Only
Memory
scanned.
• Set
Menu #35
• See
Preferential Memory Scan
key momentarily again, or press the
or
to perform either a
channels not flagged to be skipped (
( ) to for
SCAN M MEM
on page 50 for details.
channels flagged as Preferential (
( ) to for
SCAN M MSM
on page 53 for details.
SCANNING
key will cause
Standard Memory
) will be
SKIP
scan
Standard Memory
) will be
MSM
scan.
Preferential Memory
Page 49 of 83
scan