Miscellaneous Settings; Cw Identifier Setup - Yaesu FT-252 Operating Manual

Miscellaneous Settings

The ATS feature and Emergency channel operation includes a CW identifier, as dis-
cussed previously. Every ten minutes during ATS operation or every one minute during
Emergency channel operation, the radio can be instructed to send "DE (your callsign)
K" (ATS feature) and "SOS DE (your callsign)" (Emergency channel operation) if this
feature is enabled. The callsign field may contain up to 6 characters.
Here's how to program the CW Identifier:
1. Press the [ SET/ATS ] key to enter the Set mode.
2. Rotate the DIAL knob or press the [ p ] / [ q ] key to select
Set Mode Item 10:
3. Press the [ SET/ATS ] key momentarily to display any
previously-stored callsign.
4. Press the [ F/MW ] key again to clear any previous callsign.
5. Rotate the DIAL knob to select the first letter/number of
your callsign, then press the [ F/MW ] key momentarily to
save the first letter/number and move on to the next char-
acter.
6. Repeat the previous step, as many times as necessary, to
complete your callsign. If you make a mistake, press the
[ q ] key to move back to the previous letter/number's slot,
then re-select the correct letter/number.
7. When you have finished entering your entire callsign and
it contains less than 6 characters, press and hold in the [ F/
MW ] key for one second to confirm the callsign. (if you
callsign has exactly 6 characters, you do not need to press and hold in [ F/MW ] in this
step).
8. Press the PTT switch to save the settings and exit to normal operation.
9. Press the [ SET/ATS ] key to enter the Set mode.
10. Rotate the DIAL knob or press the [ p ] / [ q ] key to select
Set Mode Item 11:
11. Press the [ SET/ATS ] key momentarily, then rotate the
DIAL knob to set this Item to "
ID function).
12. Press the PTT switch to save the settings and exit to normal operation.
46

CW Identifier Setup

.
CW WRT
.
CWID
TX ON
" (to enable the CW
FT-252 O M
peraTing anual