Store A Frequency In Memory; Create A Name Tag For A Memory Channel - Yaesu FT-8800R Operating Manual

Store a Frequency in Memory

To store a frequency in a memory channel:
1. Select the desired frequency while operating in the
sure set up any desired
The power level may also be set at this time, if you wish to store it.
2. Press and hold in the
(blinking) on the display.
3. Within ten seconds of pressing the
microphone's
storage. If the channel is already occupied by data stored previously, the channel's
frequency will appear on the display.
4. Press the
To name a memory channel, see Create a Name Tag for a Memory
Channel below.

Create a Name Tag for a Memory Channel

To add an Alpha-numeric Name Tag to a memory:
1. Press the
2. Rotate the
3. Press the
4. Press the
character at this location will blink.
5. Rotate the
the blinking location, then press the
next character.
6. Again rotate the
press the
you make a mistake, press the microphone's
previous character slot, then re-select the correct letter, number, or symbol.
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
or
CTCSS DCS
key for ½ second. A memory number will appear
SET
and buttons, to select the desired memory channel for
key momentarily to save the entry and exit to normal operation.
SET
key momentarily to enter the
SET
knob to select
DIAL
knob momentarily to display
DIAL
knob momentarily to select the first character location. The
DIAL
knob to select the apha-numeric character you wish to store in
DIAL
knob to select the desired letter, number, or symbol, then
DIAL
knob momentarily to move on to the next character location. If
DIAL
mode on the
VFO
tones, as well as any desired repeater offset.
key, use the
SET
mode.
Set
.
Menu #25 NAME
". . . . . ."
knob momentarily to move on to the
DIAL
button to move back to the
REGULAR MEMORY
band. Be
Main
knob, or the
DIAL
.
Page 36 of 83
0.