Cw Identifier Setup - Yaesu FT-25R Advance Manual

ARTS (Automatic Range Transponder System)
4. Press the [▲] or [▼] key to select "BEEP", then
press the F key to enable adjustment of the ARTS
Alert Beep options.
5. Press the [▲] or [▼] key to select one of the options described above.
6. Press the PTT switch to save the new setting and return to normal operation.

CW Identifier Setup

The transceiver may be programmed to send a CW identification ("DE (your callsign)
K") every ten minutes during ARTS operation. The callsign field may contain up to 6
characters.
1. Press and hold the F key to enter the Set mode.
2. Press the [▲] or [▼] key to select Set Mode Item "9 CW ID".
3. Press the F key to enable adjustment of this Set Mode Item.
4. Press the F key, then press the [▲] or [▼] key to
select "TX : ON"
5. Press the F key to save the new setting.
6. Press the [▲] or [▼] key to select the "ID".
7. Press the Alphabet / Numeric keys to input your callsign.
• After inputting a character of the callsign, press the [▲] key to move the cursor to the
next character position.
• To correct a mistake, press the [▼] key repeatedly until the cursor returns to the
character position.
To check the work by monitoring the callsign, press the MONI/T.CALL
key.
8. When you have finished entering the entire callsign and it contains less than 6 char-
acters, press and hold the F key to save the callsign.
9. Press the PTT switch to save the new setting and return to normal operation.
To monitor and check the entered callsign, repeat steps 1 - 6 above,
then press the MONI/T.CALL key.
FT-25R/FT-25E Advance Manual
27