Transfer Data Between Two Ft−8800Rs - Yaesu FT-8800R Operating Manual

Transfer Data between two FT−8800Rs
You can transfer all data stored in one
feature. This requires a user-constructed
Cloning
jacks on the two transceivers, as shown below.
To clone from one transceiver to another:
1. Insert the
Cloning Cable
2. Turn both transceivers off, then press and hold in the
while turning the power on again.
3. Rotate the
. The display will disappear for a moment, then the
SET key
appear on the display.
4. On the
destination radio
appear on the display.
5. Now, on the
appear on the display, and the cloning data transfer will immediately begin.
6. If there is a problem during the cloning process,
Check your cable connections, and try again.
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
FT−8800R
into the
knob on each radio to select
Right DIAL
, press the
, press the
source radio
to another
FT−8800R
cable which connects the
Cloning
jack of each transceiver.
DATA
CLONE START
key. The
Left
key. The
Left
CLONE ERROR
by utilizing the handy
DATA
key on each radio
Left
, then press the
notation will
CLONE
indicator will
CLONE -RX-
indicator will
CLONE -TX-
will be displayed.
Page 64 of 83
CLONE