Select The Channel Step; Set The Display Brightness - Yaesu FT-8800R Operating Manual

Select the Channel Step

The 's synthesizer provides the option of utilizing channel steps of
FT−8800R
/ / / / / /
5 10 12.5 15 20 25 50
requirements. The
FT−8800R
operating band which probably are satisfactory for most operation. However, if you need to
change the channel step increments, the procedure to do so is very easy; remember to get set
up on the desired band before making any changes, as different steps may be programmed for
each operating band.
1. Press the
2. Rotate the
3. Press the
new channel step size.
4. Press and hold in the
normal operation.

Set the Display Brightness

The display illumination has been specially engineered to provide high visibility
FT−8800R
with minimal disruption of your night vision while you are driving. The brightness of the
display is manually adjustable, using following procedure:
1. Press the
2. Rotate the
3. Press the
comfortable brightness level:
4. Press and hold in the
normal operation.
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
kHz per step, any number of which may be important to your operating
is set up at the factory with different default steps on each
key momentarily to enter the
SET
knob to select
DIAL
knob momentarily, then rotate the
DIAL
knob for ½ second to save the new setting and exit to
DIAL
key momentarily to enter the
SET
knob to select
DIAL
knob momentarily, then rotate the
DIAL
DIM 1
knob for ½ second to save the new setting and exit to
DIAL
mode.
Set
.
Menu #38 STEP
mode.
Set
.
Menu #9 DIMMER
, , , or
DIM 2 DIM 3 DIM.OFF
COMMON TASKS
knob to select the
DIAL
knob to select a
DIAL
(no illumination).
Page 22 of 83