Displaying The Memory Tag; Scan Skip Setting; Recall A Memory Channel Other Than The Last Used Vfo Frequency - Yaesu FTDX10 Operation Manual

• Displaying the Memory Tag

The "Frequency display" or "Alpha tag display"
format may be selected.
1. Press the [M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
desired memory channel.
Alternately, the memory channel may be se-
lected by rotating the [FUNC] knob.
3. Touch [DISPLAY TYPE] area.
4. Rotate the [FUNC] knob to select the desired
display type.
FREQ Frequency
NAME
Memory Tag
● Press the [FUNC] knob for 2 seconds, then
turn the [FUNC] knob to select [DISPLAY
TYPE], press the [FUNC] knob, rotate the
[FUNC] knob to select the display method,
then press the [FUNC] knob to change it.
After making changes, touch [BACK] or ro-
tate the [FUNC] knob to select [BACK] then
press the [FUNC] knob to return to the state
of step 1.
5. Touch [BACK] or press the [M] key to save
the new setting and return to normal opera-
tion.

• Scan Skip Setting

The "Frequency display" or "Name display" format
may be selected.
1. Press the [M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
Memory Channel to be skipped during scan-
ning.
Alternately, the memory channel may be se-
lected by rotating the [FUNC] knob.
3. Touch [SCAN MEMORY] area.
4. Rotate the [FUNC] knob to select "SKIP",
then press the [FUNC] knob.
● "SKIP", may also be set by pressing the
[FUNC] knob for 2 seconds, rotate the
[FUNC] knob to select [SCAN MEMORY],
press the [FUNC] knob, rotate the [FUNC]
knob to select "SKIP", and press the [FUNC]
knob.
After changing the settings, touch [BACK]
72
or rotate the [FUNC] knob to select [BACK]
and press the [FUNC] knob to return to the
state of step 1.
"X" lights up for channels for which "SKIP" is
set.
5. Touch [BACK] or press the [M] key to save
the new setting and return to normal opera-
tion.
To re-institute a channel into the scanning
loop, select "SCAN" in step 4 above.
V/M
This key toggles frequency control between VFO
and the memory system.
The contents of the memory channels can be
recalled and used later.
• Recall a Memory Channel other than
the last used VFO frequency
1. Press the [M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
desired memory channel.
Alternately, the memory channel may be se-
lected by rotating the [FUNC] knob.
3. Press the [FUNC] knob.
Memory channels can also be called up in
the following method.
1. Press the [V/M] key.
2. Press and hold the [STEP/MCH] key.
The LED inside this key blinks.
3. Rotate the MPVD ring to select the de-
sired memory channel.
● While using the recalled memory, the stored
frequency and operating mode can be
changed temporarily (see "Memory Tune
Operation" on page #72).
4. To exit from memory mode and return to the
VFO mode, press the [V/M] key.
If a memory group is set, the channels
stored in the selected memory group may
be recalled.