Table of Contents
Advertisement
Attach emergency stop key.
Confirm that the emergency stop key is in place in the bottom of the console handrail. The
1.
treadmill will not run without the key in place.
Emergency
Stop Key
When not in use store the e-stop clip on the storage tab located under the console handrail.
Visually inspect the treadmill.
1.
Carefully examine the treadmill to ensure that the assembly is correct and complete.
Setup
Use the following instructions to setup the units settings.
CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet on
the two steps.
Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
1.
Without anyone on the treadmill, plug the power cord into a power outlet from a grounded,
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the treadmill.
2.
Locate the on/off (I/O) power switch under the front end of the treadmill. Toggle it to the on
position (I).
3.
The control panel will light up and be in the Dormant Mode.
Cybex 770T-CT Treadmill Owner's Manual
Console
Handrail
33
Advertisement
Table of Contents
