CYBEX 770T-CT Owner's Manual page 29

1. Plug the display cable, located at the bottom of the upright assembly into the communication
port of the controller.
Install the Power Supply.
1. Locate the power supply, clamp and screw.
2. Secure the power supply to the base using clamp and screw.
3. Plug the AC cord into the power supply inlet.
4. Route console cable through the gray cable clip.
Connect the console cable's DIN connector to the power supply output. Make sure the two
5.
connectors snap firmly together and can not be pulled apart without pulling the sleeve back to
release it.
Cybex 770T-CT Treadmill Owner's Manual
Controller
Communication
Port
CSAFE
Cable
(Red)
A/V
Cable
Power
Supply Inlet
AC Cord
Console Cable
Screw
DIN Connector
Display
Cable
(Black)
Power
Supply
Cable
Clamp
Gray Cable
Clip
Power Supply
Output
29