Facility Safety Precautions - CYBEX 770T-CT Owner's Manual

Facility Safety Precautions

•
Instruct all users on how to clip the e-stop clip onto their clothing and carefully test it prior to using
the treadmill.
•
Instruct all users to use caution when mounting and dismounting the treadmill.
•
Use a dedicated line when operating the treadmill.
breaker per unit.
•
Connect the treadmill to a properly grounded outlet only.
•
DO NOT operate electrically powered treadmills in damp or wet locations.
•
Keep the running belt clean and dry at all times.
•
DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the
treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then,
turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the e-
stop key from the treadmill.
Immobilize the treadmill (when not in use) by removing the e-stop key.
•
•
Inspect the treadmill for worn or loose components before each use. Do not use until worn or dam-
aged parts are replaced.
•
Stop and place the treadmill at 0 degrees incline (level) after each use.
Maintain and replace worn parts regularly. Refer to "Preventive Maintenance" section of Owner's
•
Manual.
•
DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly
or (3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.
•
DO NOT place the cord near heated surfaces or sharp edges.
•
DO NOT use the treadmill outdoors.
•
DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products are be-
ing used.
Read and understand the Owner's Manual completely before using the treadmill.
•
•
Ensure all users wear proper footwear on or around all Cybex equipment.
•
Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas or on
plush carpet.
•
Provide the following clearances: 19.7 inches (0.5 m) at each side, 79 inches (2.0 m) at the back
and enough room for safe access and passage at the front of the treadmill. Be sure your treadmill
is clear of walls, equipment and other hard surfaces.
•
Disconnect power before servicing.
attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing.
•
DO NOT
If you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the
USA, contact Cybex Customer Service at 508-533-4300.
•
Use Cybex factory parts when replacing parts on the treadmill.
•
DO NOT modify the treadmill in any way.
•
DO NOT use attachments unless recommended for the treadmill by Cybex.
Ensure all User and Facility Safety Precautions are observed.
•
Cybex 770T-CT Treadmill Owner's Manual
NOTE: A dedicated line requires one circuit
11