Table of Contents
Advertisement
CAUTION: A minimum of two people are required to lift, move and assemble this
treadmill. Always use proper lifting methods when moving heavy items.
Lift and move the treadmill.
Take note of doorway widths in facility before assembly. The base is 32.5" (83 cm) wide. With
uprights installed the width is 35.6" (90.5 cm).
1.
At least two people should lift and move the treadmill to a level location where you intend to
leave it. Use proper lifting methods.
Verify the model and voltage.
1.
Verify that you have the correct model and voltage by looking at the serial number label
located at the rear of the unit. See Chapter 5, Customer Service.
Remove shield.
1.
Using a Philips screwdriver remove the seven screws securing the shield to the base.
2.
Remove shield.
Install power cord.
1.
Locate the power cord.
2.
Decide whether you will plug the power cord into a power outlet near the front of the treadmill
or the back of the treadmill. Follow the corresponding routing procedure below. Do not plug
the power cord into a power outlet at this time.
WARNING: Failure to correctly install power cord could result in serious injury or death.
Ensure the power cord is routed as instructed and does not interfere with the
full travel of the elevation system or become pinched by the elevation wheels
or treadmill frame.
Front routing: Skip to page 26.
Cybex 770T-CT Treadmill Owner's Manual
Screws
(7)
Shield
23
Advertisement
Table of Contents
