Table of Contents
Advertisement
3.
Locate the motor cover.
4.
Place the motor cover into position vertically by aligning the two tabs and four plastic
connectors. Two plastic connectors are mounted in the front cover and two in the motor cover.
If motor cover top does not fit properly, loosen the side screws on the front cover as needed.
Using a Phillips screwdriver, finish tightening the four front cover screws. Be sure the screws
5.
are securing the motor cover's tabs.
Install power cord.
1.
Locate the power cord, mounting bracket and mounting screw.
2.
Using a Phillips screwdriver, secure the power cord with the mounting bracket and mounting
screw.
Level the treadmill.
Confirm that the treadmill is on a level surface.
1.
Cybex 770T-CT Treadmill Owner's Manual
Motor
Cover
Plastic
Connectors (4)
Power Cord
Bracket
Tabs (2)
Screw
32
Advertisement
Table of Contents
