Table of Contents
Advertisement
CardioTouch Screen — While in Dormant Mode press the Cybex logo icon to access the Lock
and Toolbox options. Press the Lock screen for cleaning icon to lock the screen for 10 seconds.
The CardioTouch screen will stay locked for 10 seconds to prevent any key presses from being
processed. Clean the CardioTouch screen using a soft cloth dampened with a cleaning solution
containing rubbing alcohol.
Running Belt Maintenance
Belt and Deck — Wipe the belt surface and the deck area with a clean dry towel to minimize
the effect of friction between the deck and the running belt. This should be done often to prevent
premature wear of the deck, running belt, and the drive motor system. See the Service Schedule at
the end of this chapter.
The running belt may become loose and slip on the drive roller with each foot plant. If it does, follow
the Tensioning and Centering the Belt procedure below. See the Service Schedule in this chapter for
a minimum schedule for checking the belt tension.
Tension and Center the Belt — If the belt is slipping under each step perform this procedure:
Tools Required
•
3/4" Socket wrench
Tension the belt.
1.
Use a 3/4" socket wrench to turn each bolt 1/2 turn clockwise. Be sure to adjust each bolt
equally on each side.
2.
Press the
Quick Start icon.
Speed + to bring the speed up to 3.5-4 mph (5.6-6.4 kph). Allow the treadmill to run
3.
Press the
for a minute.
4.
Observe the belt to be sure it stays centered. If it is not centered follow step 2.
5.
Walk on the belt to see if it still slips. If it does restart this procedure at step 1 A. If you have
to do this procedure three times and it still slips call Cybex Customer Service. Follow the next
step to be sure the belt is centered.
Be careful not to over tighten the belt. Over tightening the belt can cause the belt to stretch and
require replacement.
Cybex 770T-CT Treadmill Service Manual
55
Advertisement
Table of Contents
