Table of Contents
Advertisement
Solving Problems
This table lists some common problems and their solutions.
Problem
Image background appears
dirty when received at the
other end.
Printed or sent image contains
spots.
Received image is too light.
Message appears blank at the
other end.
You want to cancel a Memory
Transmission.
You want to cancel an Imme-
diate Transmission.
You cannot add any destina-
tion in Group though it does
not reach the maximum
number.
Solution
Adjust the scan density.
The Document Feeder (AR-
DF) or exposure glass is dirty.
Clean them. See the Copy Ref-
erence manual.
Make sure that ink or eraser is
dry before setting the original.
Request the sender to increase
the image density.
When using moist, rough or
processed paper, the printed
image may be partly invisible.
Only use recommended pa-
per.
When D appears on the dis-
play, toner is beginning to run
out. Replace the toner car-
tridge soon. See the Copy Ref-
erence manual.
The original was set upside
down. Set it properly.
If the original is being stored,
press the {Clear/Stop} key.
If the original is being sent,
use "Check/Cancel TX Files"
in the Information menu.
Press the {Clear/Stop} key.
99 destinations have been pro-
grammed with the number
keys (999 with the optional
Expansion Memory). Pro-
gram more numbers with
Quick Dials or Speed Dials.
Solving Problems
Refer to
P.30 "Image Density (Con-
trast)"
---
---
See Appendix, "Acceptable
Types of Originals" in the Ad-
vanced Features manual.
---
P.12 "Setting Originals"
P.23 "Canceling a Memory
Transmission"〈BASIC FEA-
TURES〉 "Canceling a Memo-
ry Transmission"
See Chapter4, "Checking and
Canceling Transmission
Files" in the Advanced Fea-
tures manual.
P.4 "Operation Panel"
See Chapter1, "Chain Dial",
"Redial" or "Subaddress" in
the Advanced Features manu-
al.
4
73
Advertisement
Table of Contents
