Mixing Scan Settings For A Multiple - Savin 4000 Operating Instructions Manual

Fax option
Table of Contents

Advertisement

Auto Image Density
The machine automatically selects an
image density which is the most ap-
propriate for the original.
By default, Auto Image Density is se-
lected when the machine is turned on
or modes are cleared. You can change
this with the User Parameters.
A
If the Auto Image Density indica-
tor is not selected, press [Auto Im-
age Density] to turn it on.
LTWO050N.eps
Manual Image Density
Use the Image Density keys to vary
the image density within 5 levels.
A
Make sure that the [Auto Image Den-
sity] is not selected. If it is select-
ed, press [Auto Image Density] to
turn it off.
LTWO050N.eps
B
Press to change the density from
five density level.
LTWO051N.eps
Mixing Scan Settings for a
Multiple Page Original
When sending an original consisting
of several pages, you can select differ-
ent Image Density, Resolution and
Original Type settings for each page.
Set your original, select the scan set-
tings for the first page, dial and press
the {Start} key as you would normal-
ly. Then follow one of the following
two procedures.
When setting originals on the exposure
glass
While the machine is beeping, you
have about 60 seconds (10 for Imme-
diate Transmission) to select density,
resolution and original type. The re-
maining time is shown on the display.
A
Check which pages you wish to
scan with different settings.
B
Remove the previous page and set
the next page.
C
Select the Image Density, Resolu-
tion and Original Type.
LTWO190E.eps
Commu-
Receive
Confidential
nicating
File
File
Start
TX File
TEL
Manual RX
Status
Mode
LTWO054N.eps
Note
❒ Adjust settings for each page
before you press the {Start} key.
Scan Settings
2
Standard
Immediate
Detail
Trans.
Memory
Super Fine
Trans.
31

Advertisement

Table of Contents
loading

Table of Contents