ZyXEL Communications P-2812HNU-51c User Manual page 98

Chapter 5 Broadband
Table 8 Broadband Add/Edit: Routing- IPoE (VDSL/EtherWAN) (continued)
LABEL
WAN Service Type
IPv6/IPv4
DualStack
VLAN
Enable VLAN
Enter 802.1P
Priority
Enter 802.1Q VLAN
ID
IP Address
Obtain an IP
Address
Automatically
Enable DHCP
Option 60
Vendor Class
Identifier
Static IP Address
IP Address
Subnet Mask
Gateway IP
Address
Routing Feature
NAT Enable
IGMP Proxy Enable
Apply as Default
Gateway
DNS Server
Obtain DNS info
Automatically
98
DESCRIPTION
This field is available only when you select Routing in the Mode field. Select
the method of encapsulation used by your ISP.
• PPP over Ethernet (PPPoE) - PPPoE (Point to Point Protocol over
Ethernet) provides access control and billing functionality in a manner
similar to dial-up services using PPP. Select this if you have a username and
password for Internet access.
• IP over Ethernet - In this type of Internet connection, IP packets are
routed between the Ethernet interface and the WAN interface and then
formatted so that they can be understood in a bridged environment.
Select Enable to allow the Device to run IPv4 and IPv6 at the same time. If
this function is disabled, the Device only runs IPv4.
This section is available only when you select VDSL or EtherWAN in the Type
field.
Select this to add the VLAN tag (specified below) to the outgoing traffic through
this connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
This section is available only when you select Routing in the Mode field and
IPoE in the WAN Service Type field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address
is not fixed; the ISP assigns you a different one each time you connect to the
Internet. Select this if you have a dynamic IP address.
Select this to identify the vendor and functionality of the Device in DHCP
requests that the Device sends to a DHCP server when getting a WAN IP
address.
Enter the Vendor Class Identifier (Option 60), such as the type of the hardware
or firmware.
Select this option If the ISP assigned a fixed IP address.
Enter the static IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Enter the gateway IP address provided by your ISP.
Select this option to activate NAT on this connection.
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to
establish membership in a Multicast group - it is not used to carry user data.
Select this option to have the Device act as an IGMP proxy on this connection.
This allows the Device to get subscribing information and maintain a joined
member list for each multicast group. It can reduce multicast traffic
significantly.
Select this option to have the Device use the WAN interface of this connection
as the system default gateway.
This is available only when you select Apply as Default Gateway in the
Routing Feature field.
Select this to have the Device get the DNS server addresses from the ISP
automatically.
P-2812HNU(L)-Fx Series User's Guide