ZyXEL Communications P-2812HNU-51c User Manual page 92

Chapter 5 Broadband
Click Network Setting > Broadband. The following screen opens.
Figure 16 Network Setting > Broadband
The following table describes the fields in this screen.
Table 6 Network Setting > Broadband
LABEL
Switch WAN Mode
Type
Add new WAN
Interface
#
Name
Type
Mode
Encapsulation
IPv6
VPI
VCI
Vlan8021p
VlanMuxId
ATM QoS
IGMP Proxy
NAT
92
DESCRIPTION
If you prefer not to use a DSL line and you have another broadband modem or
router (such as ADSL) available, you can select EtherWAN from the drop-
down list box and click Switch WAN Interface. The Device will use Ethernet
WAN as the WAN mode.
Click this to create a new WAN interface.
This is the index number of the connection.
This is the service name of the connection.
This shows the type of interface used by this connection.
This shows whether the connection is in routing mode or bridge mode.
This shows the method of encapsulation used by this connection.
This shows whether IPv6 is enabled.
This is the Virtual Path Identifier (VPI).
This is the Virtual Channel Identifier (VCI).
This indicates the 802.1P priority level assigned to traffic sent through this
connection. This displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this
connection. This displays N/A when there is no VLAN ID number assigned.
This shows the ATM Quality of Service (QoS) type configured for this
connection. This displays N/A when there is no ATM QoS assigned.
This shows whether IGMP (Internet Group Multicast Protocol) is activated or
not for this connection. IGMP is not available when the connection uses the
bridging service.
This shows whether NAT is activated or not for this connection. NAT is not
available when the connection uses the bridging service.
P-2812HNU(L)-Fx Series User's Guide