ZyXEL Communications P-2812HNU-51c User Manual page 112

Chapter 5 Broadband
If you select VDSL or EtherWAN as the interface type, the following screen appears.
Figure 27 Broadband Add/Edit: Bridge (VDSL/EtherWAN)
The following table describes the fields in this screen.
Table 12 Broadband Add/Edit: Bridge (VDSL/EtherWAN)
LABEL
General
Name
Type
Mode
VLAN
Enable VLAN
Enter 802.1P
Priority
Enter 802.1Q VLAN
ID
112
DESCRIPTION
Enter a service name of the connection.
Select VDSL or EtherWAN as the interface that you want to configure.
VDSL: The Device uses the VDSL technology for data transmission over the
DSL port.
EtherWAN: The Device transmits data over the Ethernet WAN port. Select this
if you have a DSL router or modem in your network already.
Select Bridge when your ISP provides you more than one IP address and you
want the connected computers to get individual IP address from ISP's DHCP
server directly. If you select Bridge, you cannot use routing functions, such as
QoS, Firewall, DHCP server and NAT on traffic from the selected LAN port(s).
This section is available only when you select VDSL or EtherWAN in the Type
field.
Select this to add the VLAN Tag (specified below) to the outgoing traffic
through this connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
P-2812HNU(L)-Fx Series User's Guide