ZyXEL Communications P-2812HNU-51c User Manual page 94

Chapter 5 Broadband
The following table describes the fields in this screen. /EtherWAN
Table 7 Broadband Add/Edit: Routing- PPPoE (VDSL)
LABEL
General
Name
Type
Mode
WAN Service Type
IPv6/IPv4
DualStack
VLAN
Enable VLAN
Enter 802.1P
Priority
Enter 802.1Q VLAN
ID
PPP Information
PPP User Name
PPP Password
PPPoE Service
Name
Authentication
Mode
94
DESCRIPTION
Enter a service name of the connection.
Select VDSL or EtherWAN as the interface that you want to configure.
VDSL: The Device uses the VDSL technology for data transmission over the
DSL port.
EtherWAN: The Device transmits data over the Ethernet WAN port. Select this
if you have a DSL router or modem in your network already.
Select Routing (default) from the drop-down list box if your ISP give you one
IP address only and you want multiple computers to share an Internet account.
This field is available only when you select Routing in the Mode field. Select
the method of encapsulation used by your ISP.
• PPP over Ethernet (PPPoE) - PPPoE (Point to Point Protocol over
Ethernet) provides access control and billing functionality in a manner
similar to dial-up services using PPP. Select this if you have a username and
password for Internet access.
• IP over Ethernet - In this type of Internet connection, IP packets are
routed between the Ethernet interface and the WAN interface and then
formatted so that they can be understood in a bridged environment.
Select Enable to allow the Device to run IPv4 and IPv6 at the same time. If
this function is disabled, the Device only runs IPv4.
This section is available only when you select VDSL or EtherWAN in the Type
field.
Select this to add the VLAN tag (specified below) to the outgoing traffic through
this connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
This section is available only when you select Routing in the Mode field and
PPPoE in the WAN Service Type field.
Enter the user name exactly as your ISP assigned. If assigned a name in the
form user@domain where domain identifies a service name, then enter both
components exactly as given.
Enter the password associated with the user name above.
Type the name of your PPPoE service here.
The Device supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP;
however, PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing
calls. Options are:
• AUTO: Your Device accepts either CHAP or PAP when requested by this
remote node.
• CHAP: Your Device accepts CHAP only.
• PAP: Your Device accepts PAP only.
• MS-CHAP: Your Device accepts MSCHAP only. MS-CHAP is the Microsoft
version of the CHAP.
P-2812HNU(L)-Fx Series User's Guide