Figure 20 Security Setting: Wep; Table 6 Security Setting: Wep - ZyXEL Communications G-210H User Manual

Chapter 4 ZyXEL Utility - Windows
4.4.1.1 WEP Encryption

Figure 20 Security Setting: WEP

The following table describes the labels in Security Setting: WEP screen.

Table 6 Security Setting: WEP

LABEL
Security Setting
Security
Authentication
Transmit Key
Key 1 ~ Key 4
Back
Save
Exit
36
DESCRIPTION
Select WEP from the drop-down list.
Select an authentication method. Choices are Open and Shared.
Refer to Section 3.2.1.1.2 on page 26
Select a default WEP key to use for data encryption.
The WEP keys are used to encrypt data. Both the G-210H and the AP or peer
device must use the same WEP key for data transmission. Enter the WEP key in
the field provided.
If you select Hex, enter 10 or 26 hexadecimal characters in the range of "A-F", "a-
f" and "0-9" (for example, 11AA22BB33) for a 64-bit or 128-bit WEP key
respectively.
If you select ASCII, enter any 5 or 13 ASCII characters (case sensitive) ranging
from "a-z", "A-Z" and "0-9" (for example, MyKey) for a 64-bit or 128-bit WEP key
respectively.
Note: The values for the WEP keys must be set up exactly the
same on all wireless devices in the same wireless LAN.
Click Back to go to the Site Survey screen to select and connect to another
network.
Click Save to confirm your selections and advance to the Link Info screen.
Click Exit to return to the Site Survey screen without saving.
for more information.
G-210H User's Guide