Wmm Advanced Setting; Table 15 Windows: Adapter - ZyXEL Communications G-210H User Manual

The following table describes the labels in this screen.

Table 15 Windows: Adapter

LABEL
Adapter Setting
Transfer Rate
Wireless Mode
11B/G Protection
Enable Tx Burst
Fast Roaming at
Disable WMM/
Enable WMM
Save

4.6.1 WMM Advanced Setting

Click Enable WMM in the Adapter screen to configure advanced WMM settings.
This screen is only available to Windows XP/2000 users.
G-210H User's Guide
DESCRIPTION
In most networking scenarios, the factory default Auto setting is the most efficient
and allows your G-210H to operate at the highest possible transmission (data)
rate.
If you want to select a specific transmission rate, select one that the AP or peer
wireless device supports.
Select 802.11 B/G mixed to have the G-210H connect to either an IEEE 802.11g
or IEEE 802.11b wireless device.
Select 802.11 B only to have the G-210H connect to an IEEE 802.11b wireless
device only.
Enabling this feature can help prevent collisions in mixed-mode networks
(networks with both IEEE 802.11b and IEEE 802.11g traffic).
Select Auto to have the G-210H send an RTS (Request to Send) message to the
AP and wait for AP's CTS (Clear to Send) response before transmitting data when
the G-210H is connecting to an AP with this feature enabled.
Select On to have the G-210H always transmit data after a RTS/CTS handshake
even when the G-210H is connecting to an AP with this feature disabled.
Select Off to disable 11B/G protection.
Select the check box to increase the throughput and improve transmission speed.
This only works when an AP or peer device supports this function.
When the signal strength is too low, you may want to connect to a closer AP. Fast
roaming allows you to connect to the closer AP without interrupting the wireless
connection.
Select the check box to enable fast roaming at the specified transmitting power.
The G-210H will enter roaming mode when dBm reaches a certain level.
WMM (Wi-Fi MultiMedia) QoS (Quality of Service) allows you to prioritize wireless
traffic according to the delivery requirements of individual services. To do this, you
must enable WMM QoS on all wireless devices in your network.
Click Disable WMM to deactivate WMM QoS on the G-210H.
Click Enable WMM to activate WMM QoS on the G-210H and display the WMM
Advanced Setting screen.
Click Save to save the changes to the G-210H.
Chapter 4 ZyXEL Utility - Windows
49