Figure 34 Adapter: Wmm Advanced Setting; Table 16 Adapter: Wmm Advanced Setting - ZyXEL Communications G-210H User Manual

Chapter 4 ZyXEL Utility - Windows

Figure 34 Adapter: WMM Advanced Setting

The following table describes the labels in this screen.

Table 16 Adapter: WMM Advanced Setting

LABEL
WMM-Power
Save Enable
Direct Link
MAC Address
Timeout Value
Apply
Direct Link Status
50
DESCRIPTION
Select this option to extend the battery life of your mobile devices (especially
useful for small devices that are running multimedia applications). The G-210H
goes to sleep mode to save power when it is not transmitting data. The AP buffers
the packets sent to the G-210H till the G-210H "wakes up". The G-210H wakes up
periodically to check for incoming data.
Note: This works only if the wireless device to which the G-210H is
connected also supports this feature.
Select this option to enable DLS (Direct Link Setup) on the G-210H. If there are
two DLS-enabled devices in the same wireless network, this allows the two
devices to communicate with each other directly. The packets will not go through
the AP and can increase throughput.
You need to enter the peer device's MAC address in this screen.
The G-210H can associate with up to four DLS clients at a time, but you can only
enter one device's MAC address in the G-210H's utility. To have the G-210H set
up a second DLS connection, enter the G-210H's MAC address in another peer
device.
Note: This feature is applicable only when the G-210H is in
Infrastructure mode and the connected AP or wireless router
is also DLS-enabled.
Enter the MAC address of the peer device that supports DLS.
Enter the time in seconds (from 1 to 65535) for the G-210H to wait before it
automatically disconnects from the peer device when there is no traffic between
them.
Click Apply to save your changes in this section.
G-210H User's Guide