Video Select; Adjusting The Brightness Of The Display (Dimmer) - Pioneer VSX-D1011-G Operating Instructions Manual

Video Select

This function allows you to listen to one sound source while you watch a different video source on your TV. The
sound source is set in the normal fashion as explained on page 41. You then change the video input with the
VIDEO SEL button.
RECEIVER
MULTI SYSTEM
OPERATION OFF
MULTI CONTROL
DVD/LD TV / SAT VCR1/DVR
VCR 2 C D TUNER
ACOUSTIC
MOVIE MUSIC
EQ
SURROUND SB CH
MODE
MODE
STEREO/
ENTER MIDNIGHT
DIRECT
MASTER
VOLUME
MENU TUNER EDIT TEXT ON
TUNE
SYSTEM
SETUP
ST
ENTER
AUDIO
TUNE
−
CHANNEL TEXT OFF BAND
RF ATT D.ACCESS MPX
DIMMER LOUDNESS TONE
SIGNAL SEL DNR BASS/TREBLE
2
VIDEO SEL HI-BIT
TV CONTROL
CHANNEL VOLUME
RECEIVER

Adjusting the Brightness of the Display (DIMMER)

Use the display DIMMER button to adjust the brightness of the fluorescent display.
RECEIVER
MULTI
OPERATION
MULTI CONTROL
DVD/LD TV / SAT
VCR 2 C D
ACOUSTIC
MOVIE MUSIC
SURROUND
MODE
STEREO/
DIRECT ENTER
RF ATT D.ACCESS
2
DIMMER LOUDNESS
SIGNAL SEL DNR BASS/TREBLE
VIDEO SEL HI-BIT
TV CONTROL
CHANNEL
1 Press RECEIVER.
SOURCE
2 Press the VIDEO SEL button on the
TV CONT
1
RECEIVER
INPUT
MULTI CH
INPUT
MUTE
TOP MENU
GUIDE
ST
RETURN
+
CHANNEL
CLASS
EFFECT/CH SEL
ENTER
DISC
+ −
+
10
SUB TITLE
REMOTE
SETUP
SOURCE
SYSTEM
OFF
VCR1/DVR TV CONT
1
TUNER RECEIVER
INPUT
EQ
MULTI CH
SB CH
MODE INPUT
MIDNIGHT
MUTE
MPX CLASS
TONE EFFECT/CH SEL
ENTER
DISC
+ −
+
10
SUB TITLE
VOLUME REMOTE
SETUP
remote control to cycle through the
different possible video inputs.
The first press shows the video input you are currently
using. After that pressing VIDEO SELECT cycles though
the possibilities in the following order:
DVD/LD TV/SAT
OFF
The OFF setting means you are listening without a
video signal. (Also, when you select CD, CD-R/TAPE1,
MD/TAPE2, TUNER or LINE functions the VIDEO
SELECT will be set to off.)
After choosing a video input the display on the receiver
will show that input for about 5 seconds and then
revert to showing the listening mode the receiver is in.
• The VIDEO SELECT remains set to the input
memo
you chose until you change the audio input.
• If you change functions the receiver will reset
itself to make the video and audio inputs
correspond.
Also, if you switch the power of the receiver off
when you turn it back on the video and audio
inputs will reset so that they correspond.
1 Press RECEIVER.
2 Use the display DIMMER button on
the remote control to alternate
between the different levels of
brightness for the display.
Four levels of brightness ranging from very dim to very
bright can be selected. Each press changes the
brightness of the display. When cycling through the
options, the default brightness can also be selected.
• It is a feature of this unit that the fluorescent
memo
display will be brighter for a few seconds after
you choose a function (like DVD/LD, CD, etc.)
and then get softer. This will still happen when
you adjust the brightness but the new setting
will be the one the display softens to.
Basic Operation
VIDEO
VCR2 VCR1/DVR
53
En