Performing Multi Operations - Pioneer VSX-D1011-G Operating Instructions Manual

RECEIVER
MULTI SYSTEM
OPERATION OFF
4-
MULTI CONTROL
2
DVD/LD TV / SAT VCR1/DVR
VCR 2 C D TUNER
ACOUSTIC
MOVIE MUSIC
4-
3
SURROUND
SB CH
MODE MODE
STEREO/
DIRECT ENTER MIDNIGHT
MASTER
VOLUME
MENU TUNER EDIT TEXT ON
TUNE
SYSTEM
SETUP
ST
ENTER
AUDIO
TUNE
−
CHANNEL TEXT OFF BAND
RF ATT D.ACCESS
DIMMER LOUDNESS TONE
SIGNAL SEL DNR BASS/TREBLE
VIDEO SEL HI-BIT
TV CONTROL
CHANNEL VOLUME
RECEIVER

Performing Multi Operations

Do the following to use the MULTI OPERATIONS.
RECEIVER
MULTI SYSTEM
OPERATION
MULTI CONTROL
2
DVD/LD TV / SAT VCR1/DVR
VCR 2 C D TUNER
ACOUSTIC
MOVIE MUSIC
SURROUND
SB CH
MODE MODE
STEREO/
DIRECT ENTER MIDNIGHT
MASTER
VOLUME
SOURCE
4-
1
TV CONT
RECEIVER
INPUT
EQ
MULTI CH
INPUT
MUTE
TOP MENU
GUIDE
ST
RETURN
+
CHANNEL
MPX CLASS
EFFECT/CH SEL
ENTER
DISC
+ −
+
10
SUB TITLE
5
REMOTE
SETUP
memo
1
SOURCE
OFF
TV CONT
RECEIVER
EQ INPUT
MULTI CH
INPUT
MUTE
4 Repeat steps 2 and 3 to input multi
operations to the MULTI CONTROL
button you pressed in step 3.
You can repeat this process for up to five
commands.
For example : you could enter the following three
operations using the preceding steps 2 and 3.
1 Press the TV CONTROL button and TV
to turn on your TV (as explained above).
2 Press the DVD/LD button then
on your DVD player (if it is not a PIONEER product).
3 Press the DVD/LD button then 3 (play) to start
playing the DVD player.
When you employ multi operations (see below), these
three tasks will be performed in the same order.
5 Press the REMOTE SETUP button to
exit the multi operation setup mode.
The remote control return to their previous operation
modes.
You don't need to program power on for PIONEER
components (except for the first generation of Pioneer
DVRs), they will go on automatically if a command for
that unit is entered in the Multi Operations settings.
Also, your TV will go on automatically if a TV related
command is entered in the Multi Operations.
1 Press the MULTI OPERATION
button.
2 Press the MULTI CONTROL button
for the component that has been set
up with multi operations.
The power of the receiver (and any Pioneer components
use in the program) goes on and the programmed multi
operations are performed automatically.
Using Other Functions
(POWER)
(POWER) to turn
73
En