Remote Control Of Other Components; Setting Up The Remote Control To Control Other; Components; Recalling Settings Stored In The Remote Control - Pioneer VSX-D1011-G Operating Instructions Manual

Remote Control of Other Components

Setting Up the Remote Control to Control Other

Components

In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV,
DVD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and
buttons, you only need to use one remote control. If your component(s) are listed in the remote control's
memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn
additional operations, you can use the learning mode to input the information from the remote controls supplied
with your other components.

Recalling Settings Stored in the Remote Control

The following steps show you how to recall the setting stored in the remote control. Once a setting is recalled
and the component assigned, you can use this remote to easily operate the component.
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
memo
• See "Using Remote Control with Other Components" on pages 65–66 to operate your other
components.
• The TUNER button cannot be assigned.
RECEIVER
MULTI SYSTEM
OPERATION OFF
MULTI CONTROL
2
DVD/LD TV / SAT VCR1/DVR
VCR 2 C D TUNER
ACOUSTIC
MOVIE MUSIC
EQ
SURROUND SB CH
MODE
MODE
STEREO/
ENTER MIDNIGHT
DIRECT
MASTER
VOLUME
MENU TUNER EDIT TEXT ON
TUNE
SYSTEM
SETUP
ST
ENTER
AUDIO
TUNE
−
CHANNEL TEXT OFF BAND
RF ATT D.ACCESS MPX
DIMMER LOUDNESS TONE
3
SIGNAL SEL DNR BASS/TREBLE
VIDEO SEL HI-BIT
TV CONTROL
CHANNEL VOLUME
RECEIVER
1 While holding down the REMOTE
LED
SOURCE
TV CONT
RECEIVER
INPUT
MULTI CH
INPUT
2 Press the MULTI CONTROL button
MUTE
TOP MENU
GUIDE
ST
3 Point the remote toward the
RETURN
+
CHANNEL
1
CLASS
EFFECT/CH SEL
ENTER
DISC
+ −
+
10
SUB TITLE
1,4
REMOTE
SETUP
4 Press the REMOTE SETUP button to
SETUP button press
preset recall setup mode.
The LED begins to blink.
To cancel the preset recall setup mode press REMOTE
SETUP.
for the component you want to
control.
The LED lights continously.
component to be controlled, enter
the 4 digit setup code (see pages 96-
97 for codes).
The LED blinks.
After a code has been input the power of the compo-
nent being input will turn on or off.
The remote will return to the previous mode after
thirty seconds of inactivity.
The power of the component being input will only turn
on or off if that component is able to be turned on
directly by remote control.
Repeat steps 2 through 3 to assign preset codes
for as many components as necessary.
If you can't get your component to respond to
any of the codes you can still program the
component into the remote control using the
procedure in the next section.
exit the preset recall setup mode.
The remote control and receiver return to their
previous operation modes.
to select the
63
En