Video Select; Changing The Display - Pioneer VSX-33TX Operating Instructions Manual

Using Other Functions

Video Select

This function allows you to listen to one sound source while you watch a different video source on your TV. The
sound source is set in the normal fashion as is explained on p.42. You then alter the video input with the VIDEO
SELECT button.
VIDEO SELECT
SOURCE
DVD
CD CD-R
VIDEO
1
LOUDNESS
SELECT
4
INPUT ATT
7
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10
EFFECT/CH SEL
TV VOL

Changing the Display

You can change the display on the front panel between the function and the sound mode by pressing the
MULTI JOG dial (see #16 on p.23).
70
RECEIVER
VCR VCR
TV
1 2
MULTI CONTROL
TUN TVC
2 3
VIDEO SELECT MULTI CH INPUT
5 6
DIGITAL NR FL DIMMER
8 9
DISC
0
ENTER
RECEIVER
TV MASTERVOLUME
MULTI JOG
Press the VIDEO SELECT button on the front
panel to cycle through the different possible
video inputs.
The first press shows the video input you are currently using.
After that pressing VIDEO SELECT cycles though the possibili-
ties in the following order:
DVD/LD
( )
OFF
The OFF setting means that no video signal is output.
After choosing a video input the display on the receiver will
show that input for about 5 seconds and then revert to showing
the sound mode the receiver is in.
The VIDEO SELECT remains set to the input
you chose until you change the audio input.
If you change audio functions the receiver will reset itself to
make the video and audio inputs correspond.
Also, if you switch the power of the receiver OFF when you
turn it back on the video and audio inputs will reset so that they
correspond.
Press the MULTI JOG dial on the front panel
to move between the function (DVD/LD, CD,
etc.) display and the sound mode display.
The display will remain on the setting you choose. If you turn
the MULTI JOG dial to select a new function the functin is
displayed.
VCR1 VCR2
TV/SAT VIDEO