NOTE
For more details on SNMP v. 3, see "Chapter 3 Using the Printer on a TCP/IP
•
Network (Windows/UNIX)" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
■ SPOOLER
OFF*, ON
Specifies whether the printer should use the Spooler function.
NOTE
For more details on the Spooler function, see "Chapter 2 Common Network
•
Settings" in Network Guide.
This item is displayed only when all the following conditions are fulfilled.
•
- NETWORK in the I/F CONNECTION options is set to ON.
- An optional hard disk is installed, and HARD DISK is set to ON.
- [Primary Network Setting] is set to [Standard Network].
Specify the setting for [Primary Network Setting] in the [Extension Card] page in
the Remote UI or in EXTENSION CARD (See p. 5-65) in the control panel.
■ START WAIT TIME
0 to 300 seconds; 0 seconds*
Specifies the time interval from when the printer is turned ON to when the protocol
starts.
NOTE
For more details on startup waiting time, see "Chapter 2 Common Network
•
Settings" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
■ REMOTE UI SET.
REMOTE UI ..........................ON*, OFF
1
SSL*
....................................OFF*, ON
*1 SSL is displayed only when an optional hard disk is installed, and HARD DISK is set to ON.
Specifies whether the printer should use the Remote UI.
NOTE
For more details on SSL, see "Chapter 2 Common Network Settings" in Network
•
Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
SETUP Menu Settings
5
5-63