Canon Color imageRUNNER LBP5975 User Manual page 483

The print is uneven.
Cause 1
Remedy
NOTE
The samples are provided in "Print Defect Samples" (See p. 7-103).
Cause 2
Remedy
The images appear rough or the data could not be printed properly when printing in
the Super Fine mode.
Cause
Remedy 1 The printer continues printing by pressing [Online]. However, the printer prints
Remedy 2 Perform a soft reset using the RESET menu, then print again with the resolution
7
Remedy 3 If you want to print in the Super Fine mode, perform a soft reset by pressing
A portion of a page is not printed.
Cause 1
Remedy 1 Clear the [Manual Scaling] check box in the printer driver. If the check box is
Remedy 2 Select the [Manual Scaling] check box in the printer driver, then specify an
7-70 When You Cannot Obtain Appropriate Printout Results
The drum cartridge has been deteriorated.
See "When Any Print Defect Appears" (p. 7-80) and solve the problem.
Paper is too moist or too dry.
Replace the paper with appropriate one and print again. (See "Paper
Requirements," on p. 3-2)
The printer could not process the data in the Super Fine mode because it
was too complicated or too large.
with the resolution level of the data being lowered.
level being lowered.
[Reset], and then increase the free space of RAM using the following
procedure.
- Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
- Install an optional expansion RAM module. (See Getting Started Guide)
The scale factor is incorrect.
cleared, the scale factor will be set according to [Page Size] and [Output Size]
automatically.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.
appropriate scale factor according to the paper size to be used.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.