In the state that the SNTP or DHCP communication is going to be performed within a
•
minute or that the Wake Up function is going to be executed within a minute, the printer
does not enter Power Save Mode 3.
Releasing Power Save Mode
The following are the methods to release Power Save Mode.
Releasing Power Save Mode
using the printer's control
panel
Releasing Power Save Mode
on the designated time every
day
Releasing Power Save Mode
from a computer
NOTE
Power Save Mode 1 and 2 are released also when an error occurs (However, Power
•
Save Mode 2 may not be released depending on the error type.).
Additionally, if CALIBRATE TIMER in TIMER SETTINGS is set to ON, and if the time
•
specified in CALIBRATE TIME has elapsed, Power Save Mode is released.
Press the key on the printer's control panel.*
* If the printer has entered Power Save Mode 3, you can
release the mode only when the control panel power
switch (sub power supply) is pressed.
Specify the time when Power Save Mode is to be
released in WAKE UP TIME. If WAKE UP TIMER in
TIMER SETTINGS is set to ON, the setting for WAKE UP
TIME is enabled.
- Send data to the printer (except for storing a job into a
box).
- Perform the following in the Remote UI.
- Operating the UTILITY menu
- Performing calibration
- Performing device controls
- Displaying the [User Maintenance Menu] page in the
[Device Settings] menu and specifying the settings
Turning the Printer ON/OFF
2
2-9