Start Wait Time; Remote Ui Set; Ethernet Driver; Init.n/W Set - Canon LBP3460 User Manual

I START WAIT TIME
0 to 300 seconds; 0 seconds*
Specifies the time interval from when the printer is turned ON to when the protocol
starts.
NOTE
For more details on startup waiting time, see "Chapter 2 Common Network
Settings" in Network Guide.
I REMOTE UI SET.
REMOTE UI ..........................ON*, OFF
Specifies whether the printer should use the Remote UI.
I ETHERNET DRIVER
AUTO DETECT.....................ON*, OFF
1
COMM.MODE* ....................HALF DUPLEX*, FULL DUPLEX
ETHERNET TYPE*
MAC ADDRESS....................(Display only)
*1 COMM.MODE and THERNET TYPE are displayed only when AUTO DETECT is set to OFF.
Configures the Ethernet driver.
NOTE
For more details on configuring the Ethernet driver, see "Chapter 2 Common
Network Settings" in Network Guide.
I INIT.N/W SET.
-
By the initialization in this item, you can reset the network settings to the default
settings.
The network settings can be initialized using the following procedure.
1.
Press [Settings].
2.
Select INTERFACE MENU using [
3.
Select NETWORK MENU using [
4.
Select INIT.N/W SET. using [
5.
<OK?> is displayed. The initialization starts by pressing [OK].
* If you press [Online] without pressing [OK], the printer does not initialize the settings but becomes
ready to print.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
1
.............10 BASE-T*, 100 BASE-TX
] and [
] and [
] and [ ], then press [OK].
], then press [OK].
], then press [OK].
SETUP Menu Settings
5
5-33