Converting Wheel Lock From Push-To-Lock To Pull-To-Lock Or Pull-To-Lock To Push-To-Lock; Converting From Push-To-Lock To Pull-To-Lock; Converting From Pull-To-Lock To Push-To-Lock - Invacare Crossfire T6 Owner's Operator And Maintenance Manual

Converting Wheel Lock From Push-to-Lock to
Pull-to-Lock or Pull-to-Lock to Push-to-Lock
NOTE: For this procedure, refer to FIGURE 9.3.

Converting From Push-to-Lock to Pull-to-Lock

1. Remove set screw from the lower stop position (Detail "A").
NOTE: As the wheel lock handle is pushed downwards, the wheel lock will engage and then
disengage the wheel.
2. Push wheel lock handle down to access the upper stop position (Detail "B").
3. Install set screw into upper stop position.
4. Pull wheel lock handle up to engage wheel lock. If wheel lock does not properly
engage the wheel, refer to Adjusting the Wheel Lock on page 57.

Converting From Pull-to-Lock to Push-to-Lock

1. Remove set screw from the upper stop position (Detail "B").
NOTE: As the wheel lock handle is pulled upwards, the wheel lock will engage and then disengage
the wheel.
2. Pull wheel lock handle up to access the lower stop position (Detail "A").
3. Install set screw into lower stop position.
4. Push wheel lock handle down to engage wheel lock. If wheel lock does not properly
engage the wheel, refer to Adjusting the Wheel Lock on page 57.
DETAIL "A" WHEEL LOCK IN
PUSH-TO-LOCK CONFIGURATION
FIGURE 9.3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to
Part No 1134872
Wheel Lock
Handle
Set Screw
(in Lower Stop Position)
Push-to-Lock
SECTION 9—WHEEL LOCKS
DETAIL "B" WHEEL LOCK IN
PULL-TO-LOCK CONFIGURATION
(in Upper Stop Position)
59
Set Screw
Wheel Lock
Handle
™
Crossfire Series Wheelchairs