Reassembly; Installing/Removing Elevating Legrests; Installing; Removing - Invacare 3G Storm Series Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS

Reassembly

1. Replace heel strap/loop.
2. Reverse preceding steps to reassemble.
NOTE: When securing heel loop to the footrest assembly, tighten mounting screw until the spacer
is secure.
FIGURE 6.12 Replacing Composite/Articulating Footplate Heel Loop

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 6.13 on page 71.

Installing

1. Turn legrest to side (open footplate is perpendicular to wheelchair) and position
mounting holes in the legrest hinge plates with hinge pins on the wheelchair frame.
2. Install the legrest hinge plates onto the hinge pins on the wheelchair frame.
3. Rotate legrest toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footplate to correct height by loosening nut and
sliding the lower footrest assembly up or down until desired height is achieved.

Removing

1. Push the legrest release handle toward the inside of the wheelchair (facing the front of
the wheelchair) and swing the legrest to the outside of the wheelchair.
2. Lift up on the legrest and remove from the wheelchair.
3. Repeat STEPS 1- 2 for opposite side of wheelchair.
3G Storm Series® Wheelchairs
All manuals and user guides at all-guides.com
Composite
Articulating
Mounting Screw
Heel Loop
70
Mounting
Screw
Spacer
Composite
Footplate
Locknut
Articulating
Footplate
Part No 1134791