Installing Telescoping I.v. Rod - Invacare 9000 SL User Manual

Installing Telescoping I.V. Rod

Installing I.V. Holder
1. Remove the rear wheel from the wheelchair. Refer to
Removing/Installing Rear Wheels on page 77.
2. Remove the locknut and hex screw that secure the arm socket to
the wheelchair frame (Detail "A").
3. Remove the locknut that secures the back tube to the clevis bracket
(Detail "B).
4. Position the top hole on the flat portion of the I.V. holder on the
existing pivot screw of the clevis bracket as shown in Detail "B".
5. Reinstall locknut onto pivot screw. DO NOT tighten yet.
6. Thread the provided mounting screw through the lower hole on
the front cylinder section of the I.V. holder, through the side frame,
and into the locknut. Turn nut until snug fit is obtained. DO NOT
tighten yet.
7. Reinstall the arm to orient front cylinder of I.V. holder. Refer to
Removing or Replacing Armrest on page 48.
8. Once front cylinder is oriented for proper clearance of the armrest,
securely tighten both locknuts.
9. Install the I. V. rod support tube. Refer to Installing I.V. Rod Support
Tube on page 82.
Part No. 1056953
Arm Socket (Outside of
Wheelchair Frame)
DETAIL "A"
Locknut Locknut
Outside of Wheelchair
Locknut
(STEP 6)
I.V. Holder (STEP 4)
Mounting
Screw
(STEP 6)
FIGURE 12 Installing I.V. Holder
81
11 RECLINER
Hex Screw
Frame
DETAIL "B"
Back Tube
(STEP 3)
Bracket
(STEP 3)
Pivot Screw
(STEP 4)
Locknut (STEPS 3 and 5)
Invacare® 9000 Series Wheelchair
Clevis