Invacare 9000 SL User Manual page 45

5. Install new heel loop onto slide tube.
6. Install the mounting screw, spacer and locknut to secure the heel loop to the footplate. Tighten until the spacer is secure.
7. Insert the lower footrest assembly into the upper footrest assembly to desired height.
8. Perform one of the following as shown in Detail "A":
• Footplates With Spring Buttons: Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.
• Bolt-In-Place Footplates:
i. From the outside of the swingaway front rigging, insert the threaded rivet through both the front rigging support and the footplate
assembly.
ii. From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into
the threaded rivet.
iii. Using a screwdriver to hold the threaded rivet in position, securely tighten the button head screw. Torque to 32 in-lbs.
9. Rotate cam lock lever down to locked position.
Footplates with Spring Buttons
Front Rigging
Support
Release Button
Footplate
Adjustment
Assembly
Holes
Cam Lock
Lever

Swingaway footrest shown.
Part No. 1056953
Bolt-in-Place Footplates
DETAIL "A"
Button Head
Screw
Inside of
Swingaway
Front Rigging
Front Rigging
Cam Lock
Lever
FIGURE 6 Replacing Heel Loop
Threaded
Rivet
Front Rigging
Support
Outside of
Swingaway
Adjustment
Hole
Footplate
Footplate
Assembly
Assembly
45
5 FRONT RIGGINGS
g
Cam Lock
Screw
Lever
Heel Loop
Slide Tube
Footplate
Spacer
Assembly
Locknut Footplate
Invacare® 9000 Series Wheelchair