Installing Telescoping I.v. Rod; Installing I.v. Holder - Invacare 9000 SL Owner's Operator And Maintenance Manual

FIGURE 10.11 Adjusting Attendant Operated Wheel Locks
Installing Telescoping I.V.
Rod

Installing I.V. Holder

NOTE: For this procedure, refer to
FIGURE 10.12.
1. Remove the rear wheel from the
wheelchair. Refer to
Removing/Installing Rear Wheels on
page 64.
2. Remove the locknut and hex screw that
secure the arm socket to the wheelchair
frame (Detail "A").
3. Remove the locknut that secures the
back tube to the clevis bracket (Detail
"B).
4. Position the top hole on the flat portion
of the I.V. holder on the existing pivot
screw of the clevis bracket as shown in
Detail "B".
5. Reinstall locknut onto pivot screw. DO NOT tighten yet.
Part No.1056953
DETAIL "A" - WHEEL LOCK SHOE ENGAGEMENT
1/8-inch (3/16-inch
pneumatic tires)
Wheel Lock
Shoe
Tire
Bolt and Locknut
Wheel Lock Handle
Wheel Lock
Shoe
Wheel Lock
Shoe
Tire
Tire Contact
Section
Area
Recliner Tube
Rear Wheel
DETAIL "A"
Arm Socket (Outside of
Wheelchair Frame)
Locknut Locknut
Outside of
Wheelchair Frame
DETAIL "B"
Locknut
(STEP 6)
I.V. Holder (STEP 4)
Mounting
Screw
(STEP 6)
FIGURE 10.12 Installing I.V. Holder
67
SECTION 10—RECLINER
Hex Screw
Back Tube
(STEP 3)
Clevis
Bracket
(STEP 3)
Pivot Screw
(STEP 4)
Locknut (STEPS 3 and 5)
9000 Series