Replacing Back Upholstery - Invacare 9000 SL User Manual

7 SEAT AND BACK
7.2

Replacing Back Upholstery

Screw-On Back Upholstery
 This procedure applies to 9000 SL without
adjustable back angle option.
1. Flip swing-back arms up and out of the way. Refer to Using
Swing-Back Arms on page 47.
2. Remove the six mounting screws and washers that secure the
existing back upholstery to the back canes.
3. Cut the tie wraps that secure the existing back upholstery to the
wheelchair frame.
4. Securely tighten the new back upholstery to the back canes with the
six mounting screws and washers starting with the top hole of the
back cane.
5. Install two new tie wraps through the bottom holes of the
upholstery to tie the bottom of the back upholstery to the back
canes.
6. Flip swing-back arms down for use. Refer to Using Swing-Back Arms
on page 47.
Slip-On Back Upholstery

This procedure applies to 9000 XT/XDT and 9000 SL with adjustable back angle option.
1. Remove the two mounting screws and washers that secure the existing back upholstery to the back canes (Detail "A").
Invacare® 9000 Series Wheelchair
Washers
Mounting
Screws
Tie Wraps
FIGURE 7.1 Replacing Back Upholstery - Screw-On Back
52
Back Upholstery
Back Cane
Washers
Mounting Screws
Upholstery
Part No. 1056953