Adjusting/Removing/Installing Telescoping Front Rigging Support - Invacare Solara Service Manual

Drop Hook
FIGURE 5.3 - REMOVING/INSTALLING SEAT PAN DROP HOOKS - MEDIUM OR
ADJUSTING/REMOVING/INSTALLING
TELESCOPING FRONT RIGGING SUPPORT
NOTE: Refer to FIGURE 5.4 for this procedure.
BEFORE performing this procedure, refer to General Guidelines on page 13 for
additional requirements.
1. Remove the front rigging from the wheelchair. Refer to the Owner's Manual, part
number 1080556.
2. Remove the hex screw and locknut that secure the telescoping front rigging support
to the wheelchair frame.
NOTE: To adjust the existing telescoping front rigging support, proceed to STEP 4.
NOTE: To remove existing telescoping front rigging from the wheelchair frame, proceed to STEP 3.
3. Install the new telescoping front rigging support into the wheelchair frame.
4. Position the new/existing telescoping front rigging support to one (1) of the three (3)
positions.
5. Install existing hex screw through the wheelchair frame and new/existing telescoping
front rigging support.
6. Secure the new/existing telescoping front rigging support with the existing locknut.
7. Repeat STEPS 1-7 for opposite side, if necessary.
NOTE: The two (2) telescoping front rigging supports can be positioned at different depths
depending on the needs of the user.
8. Install the front rigging onto the wheelchair. Refer to the Owner's Manual, part
number 1080556.
Part No 1085787
Mounting
Screws
Locknuts
LONG FRAME ONLY
WARNING
25
SECTION 5—SEAT
Drop Hook
™ ™
Solara and Solara Limited