0
DETAIL "A" -
DETENT BALLS
Detent Balls
AND DETENT
PIN
Inside of
Wheelchair
Quick-Release Axle
Replacing Rear Wheel Handrim
WARNING
Wheelchairs with 300lbs weight limit: DO NOT
use composite handrims. Otherwise injury or
damage may occur.
If the wheelchair is equipped with permanent
axles, this procedure must be performed by a
qualified technician.
1.
Remove the rear wheel from the wheelchair. For
non-recliner models, refer to Removing/Installing Rear
Wheels on page 55. For 9000XT Recliner, refer to
Removing/Installing Rear Wheels on page 77.
2.
Remove the mounting screws that secure the handrim to rear wheel.
3.
Remove the existing handrim.
4.
Install the new handrim by reversing the preceding steps.
Part No. 1056953
Axle Bushing
FIGURE 1 Removing/Installing Rear Wheels - Quick-Release Axles
Detent
Axle Mounting
Pin
Positions
Axle Spacer (Conventional
Arms Only)
Quick-Release
Axle
Outside of
Wheelchair
Rear Wheel
Handrim
FIGURE 2 Replacing Rear Wheel Handrim
57
8 REAR WHEELS
Wheelchair
Frame
Rear Wheel
Mounting Screw
Invacare® 9000 Series Wheelchair