Invacare back extension assembly, installation and operating instructions (1 page)
Summary of Contents for Invacare 9000 Topaz
Page 1
Owner’s Operator and Maintenance Manual 9000 Topaz™Wheelchair DEALER: This manual MUST be given to the user of the wheelchair. USER: BEFORE using this wheelchair, read this manual and save for future reference. For more information regarding Invacare products, parts, and services, please visit www.invacare.com...
Page 2
APPLICABLE). IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS, CAUTIONS AND INSTRUCTIONS, CONTACT INVACARE TECHNICAL SUPPORT BEFORE ATTEMPTING TO SERVICE OR OPERATE THIS EQUIPMENT - OTHERWISE, INJURY OR DAMAGE MAY RESULT. NOTE: Updated versions of this manual are available on www.invacare.com. 9000 Topaz™Wheelchair Part No. 1100869...
3. Receive updates with product information, maintenance tips, and industry news. 4. Invacare can contact you or your provider, if servicing is needed on your product. 5. It will enable Invacare to improve product designs based on your input and needs.
11. User's Year of birth: ______________________________________________________ If at any time you wish not to receive future mailings from us, please contact us at Invacare Corporation, CRM Department, 39400 Taylor Parkway, Elyria, OH 44035, or fax to 877-619-7996 and we will remove you from our mailing list.
Page 8
Fold here Fold here Invacare Product Registration Form Please Seal with Tape Before Mailing 9000 Topaz™Wheelchair Part No. 1100869...
CHANGE WITHOUT NOTICE. WHEELCHAIR USER As a manufacturer of wheelchairs, Invacare endeavors to supply a wide variety of wheelchairs to meet many needs of the end user. However, final selection of the type of wheelchair to be used by an individual rests solely with the user and his/her healthcare professional capable of making such a selection.
Page 10
WARNING Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. 9000 Topaz™Wheelchair Part No. 1100869...
Do not remove label. Replace if damaged P/N 1134890 REV A 08/05 NOTE: 1079203 located on seat rail next to the middle H-block. WARNING DO NOT OPERATE WITHOUT THE ANTI-TIP TUBES INSTALLED. REV. 5/98 P/N 60106X144 Part No. 1100869 9000 Topaz™Wheelchair...
Do not sit or transfer into the wheelchair unless it is fully open and the seat rails are fully seated into the side frame H-blocks. DO NOT operate on roads, streets or highways. Part No. 1100869 9000 Topaz™Wheelchair...
Invacare DOES NOT recommend the use of its wheelchairs as a weight training apparatus. Invacare wheelchairs have not been designed or tested as a seat for any kind of weight training. If occupant uses wheelchair as a weight training apparatus, Invacare shall not be liable for bodily injury and the warranty will be voided.
Anti-tippers are specific to the different rear wheels and/or seat-to-floor heights. Refer to the chart in Installing Anti-Tippers on page 40 for correct usage and adjustment. If these requirements cannot be achieved, DO NOT use the wheelchair. Contact an Invacare dealer or qualified technician. Any changes to the seat-to-floor angle or seat-to-floor height may require different anti-tippers.
Individual wheelchair users often develop skills to deal with daily living activities that may differ from those described in this manual. Invacare recognizes and encourages each individual to try what works best for him/her in overcoming architectural obstacles that they may encounter.
Proper positioning is essential for your safety. When reaching, leaning, bending forward, it is important to use the front casters as a tool to maintain stability and balance. Part No. 1100869 9000 Topaz™Wheelchair...
Reach back only as far as your arm will extend without changing your sitting position. Tilting WARNING DO NOT tilt the wheelchair when occupied to traverse curbs or other such obstructions. ALWAYS use curb cuts. Otherwise, injury or damage may result. 9000 Topaz™Wheelchair Part No. 1100869...
Extreme caution is advised when it is necessary to move an unoccupied wheelchair up or down the stairs. Invacare recommends using two (2) assistants and making thorough preparations. Make sure to use only secure, non-detachable parts for hand-hold supports.
DO NOT sit or transfer into the wheelchair unless it is fully open and the seat rails are fully seated into the side frame H-blocks. Unfolding NOTE: For this procedure, refer to FIGURE 2.5. 1. Tilt the wheelchair toward you (raising the opposite wheel and caster off the ground/floor). 9000 Topaz™Wheelchair Part No. 1100869...
CAUTION DO NOT allow upholstery to hang between the cross braces. FIGURE 2.6 Folding Wheelchair 4. Place excess seat upholstery over the armrest. Part No. 1100869 9000 Topaz™Wheelchair...
❑ Check that there is no excessive side movement or binding in the rear wheels when lifted and spun. ❑ Inspect rear wheels for cracked, broken or loose spokes. ❑ Ensure all spokes are uniformly tight. ❑ Inspect handrims for signs of rough edges or peeling. 9000 Topaz™Wheelchair Part No. 1100869...
❑ Check that wheel locks are easy to engage. ❑ Ensure that casters are free of debris. ❑ Inspect seat and backs for rips and sagging. ❑ Inspect seat for damaged or missing warning label. Part No. 1100869 9000 Topaz™Wheelchair...
7. Check seat for damaged or missing warning label. 8. Replace any labels that are missing, worn, or torn. Refer to Label Location on page 11 for a listing of the labels and their locations. 9000 Topaz™Wheelchair Part No. 1100869...
1. Push the footrest release lever inward Hinge Plates 2. Rotate swingaway footrest assembly outward. 3. Lift the swingaway footrest assembly FIGURE 4.1 Installing/Removing Swingaway off the hinge pins. Footrest Assembly 4. Repeat STEPS 1-3 for the other side. Part No. 1100869 9000 Topaz™Wheelchair...
3. Repeat STEPS 1 and 2 for the other legrest assembly. NOTE: The footplates will be facing each other when locked in place. 4. While sitting in the wheelchair, adjust the legrest to the correct height. Refer to Adjusting Elevating Legrest Assembly on page 27. 9000 Topaz™Wheelchair Part No. 1100869...
2. Slide the Calfpad up or down until the desired position is obtained. 3. Secure the calfpad to the elevating legrest assembly with the two (2) mounting screws. Securely tighten. 4. Repeat STEPS 1-3 to adjust remaining calfpad. Part No. 1100869 9000 Topaz™Wheelchair...
NOTE: When securing the heel loop to the footrest assembly, tighten the mounting screw and locknut until the spacer is secure. Bolts Locknuts Mounting Heel Loop Screw Spacer Slide Tube Lower Footrest Assembly Locknut FIGURE 4.7 Heel Loop Replacement Part No. 1100869 9000 Topaz™Wheelchair...
A. Flip the height adjustment lever on the front of the armrest to the down (vertical) position. B. Pull the height adjustment lock knob on the rear of the armrest and twist 1/4-turn into the locked position. 4. Repeat STEPS 1-3 for other armrest. 9000 Topaz™Wheelchair Part No. 1100869...
700 lb version of the wheelchair is shown. The armrest pad for the 1000 lb version of the wheelchair is Armrest Assembly replaced the same way. Mounting Screws FIGURE 5.2 Replacing Desk/Full Length Armrest Pad Part No. 1100869 9000 Topaz™Wheelchair...
700 lb version of the wheelchair is shown. The armrest for the 1000 lb Armrest version of the wheelchair is Release Lever removed/replaced the same way. Arm Socket Arm Socket FIGURE 5.3 Removing or Replacing Armrest 9000 Topaz™Wheelchair Part No. 1100869...
NOTE: The following chart determines the number of mounting screws for each seat depth. SEAT DEPTH NUMBER OF SCREWS 18 inch 20 inch Mounting Warning Screws Label Seat Washers Upholstery Wheelchair Frame FIGURE 6.1 Replacing Seat Upholstery Part No. 1100869 9000 Topaz™Wheelchair...
4. Reinstall the four (4) mounting screws through the threaded mounting holes of the wheelchair frame and the back cane. Securely tighten. 5. Reinstall the four (4) locknuts. Securely tighten 9000 Topaz™Wheelchair Part No. 1100869...
Frame FIGURE 6.3 Adjusting Back Height Adjusting Seat Depth WARNING Adjusting the seat depth of the 9000 Topaz wheelchair must be performed by a qualified technician. Contact dealer/Invacare. Adjusting Seat Width WARNING Adjusting the seat width of the 9000 Topaz wheelchair must be performed by a qualified technician.
SECTION 7—REAR WHEELS Replacing/Repairing Rear Wheel Tire/Tube WARNING Replacement of rear wheel tire or tube MUST be performed by a qualified techni- cian. Part No. 1100869 9000 Topaz™Wheelchair...
D. Adjust locknuts according to freedom of caster swing. 8. Test wheelchair for maneuverability. 9. Readjust locknuts if necessary. 10. Repeat STEPS 7-9 until correct. 11. Snap dust cover over the locknut and stem. 9000 Topaz™Wheelchair Part No. 1100869...
As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced if necessary. Front Caster Mounting Adjustments WARNING Adjusting front caster mountings MUST be performed by a qualified technician. Contact dealer/Invacare. Part No. 1100869 9000 Topaz™Wheelchair...
Refer to the following charts for correct usage and adjustment. If these requirements cannot be achieved, DO NOT use the wheelchair. Contact an Invacare dealer or qualified technician. Any changes to the seat-to-floor angle or seat-to-floor height may require different anti-tippers. The correct anti-tippers MUST be ordered to maintain a 1½...
Page 41
SECTION 9—ANTI-TIPPERS/WHEEL LOCKS *NOTE: When installing/using anti-tipper 1102146 on the 9000 Topaz Anti-tipper Length wheelchair with a seat-to-floor height of Anti-tipper 15½ inches, the anti-tipper wheels must be pointed up away from the ground/floor. FIGURE 9.1 Anti-Tipper Length 1. Insert the anti-tippers with the anti-tipper wheels positioned according to the...
3. Disengage the wheel locks by reversing STEP 2. DETAIL “A” - PUSH-TO-LOCK MODEL Unlocked Locked Position Position Wheel Lock Handle DETAIL “B” - PULL-TO-LOCK MODEL Locked Unlocked Position Position Wheel Lock Handle FIGURE 9.3 Using Wheel Locks 9000 Topaz™Wheelchair Part No. 1100869...
5. The base cleans easily with any chrome or glass cleaner. The strap can be cleaned with mild soap and water. Strap Base Step Tube Clamp Locknut FIGURE 10.1 Installing Crutch and Cane Carrier 9000 Topaz™Wheelchair Part No. 1100869...
3. Pass the wheel lock extension handle through the loop end of the elastic cord. 4. Slide the wheel lock extension handle on to the wheel lock handle. 5. Repeat STEPS 1-3 for the remaining wheel lock. Part No. 1100869 9000 Topaz™Wheelchair...
2. Secure the mounting bracket to the wheelchair frame with the hex screw, spacer and locknut. 3. Telescoping I.V. with O holder only: Secure the top of the telescoping I.V. rod holder to the wheelchair frame with a tie wrap. Part No. 1100869 9000 Topaz™Wheelchair...
5. Secure the lower mounting bracket to the wheelchair frame by securely tightening the two (2) hex screws and locknuts on the mounting bracket. 6. Loosen the adjustment knob and position the IV rod to the desired height and securely tighten the adjustment knob. 9000 Topaz™Wheelchair Part No. 1100869...
4. Firmly grasp the height adjustment assembly and pull to remove from the outer tube. 5. Slide the upper mounting bracket up off the outer tube. 6. Rotate the upper mounting bracket 180° and reinstall onto the outer tube. 7. Reverse STEPS 1-5 to reassemble the telescoping I.V. rod. Part No. 1100869 9000 Topaz™Wheelchair...
Installing/Removing Push Bar NOTE: For this procedure, refer to FIGURE 10.9. NOTE: The 9000 Topaz is folded for either storage or transporting. The push bar must be removed before folding the wheelchair. Installing Push Bar 1.
A. Push the footrest release lever inward. B. Rotate swingaway footrest assembly outward. C. Lift the swingaway footrest assembly off of the hinge pins. D. Repeat STEPS A-C for the other footrest assembly. Part No. 1100869 9000 Topaz™Wheelchair...
Release Lever Footboard Support Left Footboard Release Lever Support Assembly Hinge Pins Footboard Clips Hinge Plates End Cap Hinge Left Lower Pins Footboard Right Footboard Support Tube Support Assembly Footboard FIGURE 10.10 Installing/Removing One-Piece Footboard 9000 Topaz™Wheelchair Part No. 1100869...
Invacare or a dealer, with a copy of the seller’s invoice required for coverage under this warranty. Invacare warrants the upholstered materials (seat, back and...
Page 56
Invacare Corporation Canada One Invacare Way 570 Matheson Blvd E Unit 8 Invacare, the Medallion design, and Yes, Elyria, Ohio USA Mississauga Ontario you can. are registered trademarks of 44036-2125 L4Z 4G4 Canada Invacare Corporation. 800-333-6900 800-668-5324 Topaz is a trademark of Invacare Corporation.