Dual Gns 430(W)/530(W) Interconnect/Configuration Example W/Gsu 73 - Garmin G3X Installation Manual

CONFIGURATION GUIDANCE
1. GNS #1 AND #2
A. ON THE MAIN ARINC 429 CONFIG PAGE
•
SET IN 1 SPEED TO "LOW"
•
SET IN 1 DATA TO "EFIS/AIR DATA"
•
SET OUT SPEED TO "LOW"
•
SET OUT DATA TO "GAMA 429"
•
SET SDI TO "LNAV 1" FOR GNS #1 AND "LNAV 2" FOR GNS #2
•
SET VNAV TO "ENABLE LABELS" FOR GNS #1 AND GNS #2 (WAAS UNITS ONLY)
B. ON THE MAIN RS-232 CONFIG PAGE
•
SET CHNL 1 INPUT TO "OFF"
•
SET CHNL 1 OUTPUT TO "MAPMX" (WAAS UNITS ONLY) OR "AVIATION" (NON-WAAS UNITS)
C. ON THE MAIN CDI/OBS CONFIG PAGE
•
PRESS MENU AND SELECT THE "IGNORE SEL CRS FOR VLOC?" OPTION
NOTE: MENU WILL SAY "ALLOW SEL COURSE FOR VLOC?" WHEN SET CORRECTLY
D. ON THE VOR/LOC/GS ARINC 429 CONFIG PAGE
•
SET RX AND TX SPEED TO "LOW"
•
SET SDI TO "VOR/ILS 1" FOR GNS #1 AND "VOR/ILS 2" FOR GNS #2
2. G3X
A. ON THE GDU 37X COMM CONFIG MODE PAGE
•
SET THE CONNECTED GDU 37X (PFD) RS-232 CHANNEL TO "MAPMX" (IF CONNECTED TO A WAAS
UNIT) OR "AVIATION IN" (IF CONNECTED TO A NON-WAAS UNIT) FOR GNS #1
•
SET THE CONNECTED GDU 37X (PFD OR MFD) RS-232 CHANNEL TO "MAPMX" (IF CONNECTED TO A
WAAS UNIT) OR "AVIATION IN" (IF CONNECTED TO A NON-WAAS UNIT) FOR GNS #2
•
SET ARINC 429 TX 1 FORMAT TO "EFIS/AIRDATA" AND "NAV 1 + 2"
•
SET ARINC 429 RX 1 FORMAT TO "GARMIN GPS" AND "NAV 1" FOR GNS #1
•
SET ARINC 429 RX 2 FORMAT TO "GARMIN VOR/ILS" AND "NAV 1" FOR GNS #1
•
SET ARINC 429 RX 3 FORMAT TO "GARMIN GPS" AND "NAV 2" FOR GNS #2 (IF APPLICABLE)
•
SET ARINC 429 RX 4 FORMAT TO "GARMIN VOR/ILS" AND "NAV 2" FOR GNS #2
IMPORTANT: GNS #1 AND #2 ARE DIFFERENTIATED IN THE G3X SYSTEM BY THE GDU 37X RS-232 PORT
ASSIGNMENTS. GNS #1 SHOULD ALWAYS BE CONNECTED TO A LOWER NUMBERED PORT ON THE PFD. GNS #2 CAN
BE CONNECTED TO A HIGHER NUMBERED PORT ON THE PFD OR TO ANY PORT ON THE MFD.
Figure D-2.5 Dual GNS 430(W)/530(W) Interconnect/Configuration Example w/GSU 73
190-01115-01
Rev. L
G3X Installation Manual - G3X w/GSU 73 Interconnect Drawings
Page D-9