Garmin G3X Installation Manual page 268

NOTE
For the following steps please refer to Figure 16-3 &
1. Strip back approximately 0.17 inches of insulation from each wire of the four conductor wire
harness (item 3) and crimp either a pin (item 4) or a socket (item 9) to each conductor. It is the
responsibility of the installer to determine the proper length of insulation to be removed. Wire
must be visible in the inspection hole after crimping and the insulation must be 1/64 – 1/32 inches
from the end of the contact as shown in Figure 16-3.
2. Insert newly crimped pins (or sockets) and wires (items 3 and 4) into the appropriate connector hous-
ing (item 5) location as specified by the installation specific wiring diagram.
3. Attach the module (item 1) to backshell (item 6) using screw (item 10).
4. Plug the four conductor wire harness (item 3) into the connector on the module (item 1).
5. Orient the connector housing (item 5) so that the inserted four conductor wire harness (item 3) is on
the same side of the backshell (item 6) as the module (item 1)—as shown in drawing.
6. Attach cover (item 7) to backshell (item 6) using screws (item 8).
G3X Installation Manual - Connector Installation Instructions
Page 16-4
Figure 16-3 Insulation/Contact Clearance
Figure 16-4.
190-01115-01
Rev. L