Garmin G3X Installation Manual page 133

Table 9-11 Roll Servo Autopilot Configuration Settings
Auto Trim Motor Speed
Fine Adjust Time
(Expert Setting)
Fine Adjust Amount
(Expert setting)
Figure 9-20 Roll Servo Autopilot Configuration Page
190-01115-01
Rev. L
The GSA 28 roll servo has the ability to drive the auxiliary trim motor at
various speeds.
The Auto Trim Motor Speed should be set so the auxiliary trim motor will
move as slowly as possible. The slowest possible movement will ensure
that there is no noticeable aircraft response when the auxiliary trim motor is
run during auto-trim.
The Auto Trim Motor Speed can be adjusted in percent from 5 to 100 in
steps of 5.
The GSA 28 roll servo is capable of making very small adjustments to fine
tune the aileron position. The Fine Adjust Time is the rate in which these
adjustments are made in seconds.
Fine Adjust Time is an expert level setting, and should generally be not be
changed by the installer, the default value is 0.20.
If the installer notices the aircraft doing very small oscillations, the Fine
Adjust Time and Fine Adjust Amount can be used to correct this.
The GSA 28 roll servo is capable of making very small adjustments to fine
tune the aileron position. The Fine Adjust Amount is the amount in which
these adjustments are made.
Fine Adjust Amount is an expert level setting, and should generally be not
be changed by the installer, the default value is 0.
If the installer notices the aircraft doing very small oscillations, the Fine
Adjust Time and Fine Adjust Amount can be used to correct this.
G3X Installation Manual - GSA 28 Installation
Page 9-67