Engine/Airframe Sensor Configuration; Engine/Airframe Sensors; Section 18 Engine/Airframe Sensor Configuration; Engine Sensor Installation - Garmin G3X Installation Manual

18 ENGINE/AIRFRAME SENSOR CONFIGURATION

18.1 Engine/Airframe Sensors

Each of the sensors must be correctly installed
being monitored are displayed as gauges on the EIS display (Figure 18-1) and also on the MFD's Engine
Page.
The following list of gauges, (if configured) are specifically required by FAR 91.205 and will always be
displayed on the EIS display (engine bar). Other gauges will be displayed as space permits based on a pre-
defined priority and user selections.
RPM

18.2 Engine Sensor Installation

NOTE
The following sections contain general guidance on engine and airframe sensor
installation. This information is provided for reference only. The installer should always
follow any installation guidance and instructions provided by the applicable engine,
sensor, or kit-plane manufacturer. Additionally, all installation practices should be done
in accordance with AC 43.13-1B.
Appendices E through H contain interface drawings for sensor installations using the Garmin sensor kits,
and for other sensor installations.
190-01115-01
Rev. L
(Section
Figure 18-1 EIS Display (Engine Bar)
Oil Temperature
G3X Installation Manual - Engine/Airframe Sensor Configuration
14) and configured prior to use. The Engine inputs
Oil Pressure Fuel Quantity
Page 18-1